![seadoo vts position sensor seadoo vts position sensor](https://www.promo-jetski.com/28616-large_default/camshaft-position-sensor-420664045.jpg)
So what it appears to me is that one of the magnets has gotten tired and isn't working properly anymore. However, with the motor removed if I use my finger to lift the forward end of the slide toward where the sensors are at the top of the VTS housing, suddenly the resistance drops to 670.
![seadoo vts position sensor seadoo vts position sensor](https://img.yumpu.com/38967546/1/500x640/diagnostic-procedures-sea-doonet.jpg)
At fully up, no change-as though the sensor isn't picking up the magnet on the slide. At fully down, the resistance drops to 670. At all points between fully up and fully down, the resistance is just under 10k. Next I checked the resistance between the purple and black leads. This product is an original Seadoo part which is compatible with 141 watercrafts. There has never been water in the VTS housing. The magnet on my slide is set in epoxy and is intact and fine. Trim Motor Wires: Green-Orange to Blue-Orange Either polarity, 0. I then disconnected the motor and it runs smoothly forward and backward. With trim in center positions, resistance should read 19-206 Ohms in 14.7 Ohm increments. If the trim is at its new stopping point halfway up, same deal-no click or noise from the VTS. If the trim is fully down and you press the down button on the handlebar, there are no sounds from the VTS unit. There is no sign of strain on the motor-it just stops. Utilizes OEM electronic actuator which drops into our new housing for OEM electronic trigger.
![seadoo vts position sensor seadoo vts position sensor](https://rivaracing.com/images/F144951839.jpg)
Precision machined from billet aluminum and anodized to prevent corrosion. Mounts to a variety of aftermarket 7/8' handle bars. This billet electronic throttle housing utilizes OEM electronic actuators. Raising the trim back up, it stops just a little bit past halfway. RIVA Sea-Doo Electronic Throttle Lever Assembly. The trim goes down just fine, and stops automatically. I am working on a similar problem on my 97 GSX. Online Information Monitoring Terminals For Containers And Logistics Equipments,GPS Tracker,Fuel Level Sensor,Container Management System,Intelligent.